D Cell spacer Pipe
CAUTION: These D Cell spacer pipes come with sharp burrs!
Useful for making spaces to trap solvent and patches in D cell sized solvent trap tubes.
These are a few hundredths smaller than a 381-3179 Freeze Plug, and typically slide right into a D cell solvent trap.
Cut on a band saw (USE CAUTION!!! These have rough edges, burrs, etc).
We strive to cut them as close to stated length as we can, typically they are about a 16th longer, but some times just a little shorter. A few (the last of the pipe to get cut) can be around an inch longer.
AGAIN EXPECT THE CUT ENDS TO HAVE BURRS!!! USE CAUTION!!!!
These are a few hundredths smaller than a 381-3179 Freeze Plug, and typically slide right into a D cell solvent trap.
Cut on a band saw (USE CAUTION!!! These have rough edges, burrs, etc).
We strive to cut them as close to stated length as we can, typically they are about a 16th longer, but some times just a little shorter. A few (the last of the pipe to get cut) can be around an inch longer.
AGAIN EXPECT THE CUT ENDS TO HAVE BURRS!!! USE CAUTION!!!!
Type 304 Stainless, 2", 3", & 6" long
Type 304 stainless to hold up to the worst solvents you can subject them too. Schedule 10S thickness for strength!
OD: ~1.318"
Wall: ~.100"
Weight per 6": 10.6 oz (approximate)
OD: ~1.318"
Wall: ~.100"
Weight per 6": 10.6 oz (approximate)
Titanium, 4" long
Light weight but strong Titanium (3Al-2.5V) is about half the weight as stainless and still really tough!
OD: ~1.313"
Wall; ~.083
Weight per 4": 3.3 oz
Weight per 6": 4.9 oz (approximate only for comparison with stainless)
OD: ~1.313"
Wall; ~.083
Weight per 4": 3.3 oz
Weight per 6": 4.9 oz (approximate only for comparison with stainless)